Which Internal Routing Protocol Would Use If You Needed To Route Between Cisco And Non-cisco Equipment?
Edit Question:
Question (Required)Add details:Category
Answer 1:
Rip and ospf these two routing protocols used when route packet with the cisco and non cisco equipment because both routing protocols are open standard.
* Feel free to post anything but please do not spam or troll. Also avoid writing "I don't know", "I want to know as well", "Idk" etc. We record IP addresses of all the spammers and trolls so that we can reach them if required. ok
Get an email notification whenever this question receives an answer/comment. Enter your email address below:
We will never share your email with anyone and will never spam